Chapter 16.12
REQUIREMENTS BY TYPE OF SUBDIVISION

Sections:

16.12.010    Design and improvement generally.

16.12.020    Industrial subdivisions.

16.12.030    Commercial subdivisions.

16.12.040    Residential subdivisions.

16.12.010 Design and improvement generally:

Subdivision design and improvements shall be required as set out in this title. (Ord. 98, Art. 2(part), 1966).

16.12.020 Industrial subdivisions.

A.    Minimum lot area and width for industrial subdivisions shall be as stipulated in the zoning ordinance, but not less than ten thousand square feet and one hundred feet in width.

B.    Street Design. Street design shall be as set forth in Sections 16.36.060 and 16.36.070 for industrial areas.

C.    Improvements. All improvements shall be as set out in Chapter 16.36 except Sections 16.36.060 and 16.36.070.

D.    Other Regulations. All other regulations set out in this title shall be complied with in the development of industrial subdivisions. (Ord. 133 (part), 1973; Ord. 98 §5, 1966).

16.12.030 Commercial subdivisions.

A.    Minimum lot area and width for commercial subdivisions shall be five thousand square feet and fifty feet width, provided that the planning commission may reduce the lot sizes not more than fifty percent when the total lot size and land used for parking and landscaping in undivided interest equals the required lot size.

B.    Street Design. Street design shall be as set out in Section 16.36.060 and 16.36.070 for commercial area.

C.    Improvements. All improvements shall be as set out in Chapter 16.36 except Sections 16.36.060 and 16.36.070.

D.    Other Regulations. All other regulations set out in this title shall be complied with in the development of commercial subdivisions. (Ord. 98 §6, 1966).

16.12.040 Residential subdivisions.

A.    Minimum lot area and width for residential subdivisions shall be six thousand square feet and sixty feet width, unless greater lot area and width is stipulated in the zoning ordinance for the area to be subdivided. Lot size may be reduced through the use of Section 16.36.050 herein.

B.    Width at front property line may be reduced to thirty-five feet where the frontage abuts the outside of any sharp curve and to twenty feet on panhandle development where not more than one lot is served by the panhandle. Sharp curve means a centerline radius of less than one hundred feet.

C.    Mass recontouring may be allowed when approved by the planning commission, provided that such contouring shall be planted or reforested to approval of said planning commission.

D.    Improvements. All design and improvements shall be as set forth in Chapters 16.20 and 16.36.

E.    Regulations. All other regulations set out in this ordinance shall be complied with in the development of subdivisions. (Ord. 133 (part), 1973; Ord. 98 §7, 1966).