CHAPTER 2
ZONING
ARTICLE 9. REGULATIONS IN MANUFACTURING (M) DISTRICTS
SECTION:
§9110 Manufacturing Or (M) District
§9112 Uses Permitted Subject To First Securing A Use Permit
§9114 Building Site Area Required
§9110 MANUFACTURING OR (M) DISTRICT
The regulations contained in this Article shall apply in all Manufacturing (M) Districts and shall be subject to the provisions of Article 16 of this Chapter. The purpose of this Article is to implement the general plan policies for industrial areas. (Ord. 793, §2, adopted 1982)
§9111 USES ALLOWED
The following uses are allowed in Manufacturing (M) Districts:
A. Wholesale and storage establishments; light and heavy industrial and manufacturing use which, in connection with, has no appreciable offensive or objectionable noise, odor, dust or nuisance factor; such as service stations, auto wrecking, blacksmith shops, building materials yards, feed and fuel yards, junk yards, lumber yards, machine shops, planing mills, storage of goods and materials, and other uses which in the opinion of the Planning Commission are of a similar nature.
B. Accessory uses to any allowed or permitted uses. (Ord. 793, §2, adopted 1982)
§9112 USES PERMITTED SUBJECT TO FIRST SECURING A USE PERMIT
The following uses may be permitted in Manufacturing (M) Districts subject to first securing a use permit, as provided in this chapter, in each case:
Cannabis cultivation – Large indoor.
Cannabis cultivation – Large mixed light.
Cannabis cultivation – Medium indoor.
Cannabis cultivation – Medium mixed light.
Cannabis cultivation – Processor.
Cannabis cultivation – Small indoor.
Cannabis cultivation – Small mixed light.
Cannabis cultivation – Specialty cottage.
Cannabis cultivation – Specialty indoor.
Cannabis cultivation – Specialty mixed light.
Cannabis distributor.
Cannabis manufacturer – Level 1.
Cannabis manufacturer – Packaging.
Cannabis manufacturer Level 1 – Shared Use.
Cannabis microbusiness.
Cannabis nursery.
Cannabis retailer.
Cannabis testing laboratory.
Industrial, manufacturing, or storage uses which may be objectionable by reason of production of smoke, dust, noise, radioactivity, vibration, bright light or other causes.
Recreational uses, hotels, motels, mobile home parks, retail stores, offices, service establishments.
Resident manager/security personnel housing. (Ord. 828, §2, adopted 1984; Ord. 1186, §3, adopted 2018; Ord. 1226, §5, adopted 2022)
§9113 BUILDING HEIGHT LIMIT
The maximum height of any building in Manufacturing (M) Districts shall by fifty feet (50’). (Ord. 793, §2, adopted 1982)
§9114 BUILDING SITE AREA REQUIRED
In Manufacturing (M) Districts the building site area required for each main building shall be a minimum of seven thousand (7,000) square feet in area. (Ord. 793, §2, adopted 1982)
§9115 YARDS REQUIRED
In Manufacturing (M) Districts yards shall be required in the following minimum widths:
A. Front Yards: None required on interior parcels. On corner parcels there shall be a ten foot (10’) setback for a distance of ten feet (10’) along both street frontages measured from the point where the property lines meet at the corner.
B. Rear and Side Yards: None required, except where the rear or side of a lot abuts on an R-1, R-2 or R-3 District in which case the rear or side yard shall be that of the adjoining zone. (Ord. 793, §2, adopted 1982)
§9116 PARKING REQUIRED
The minimum parking area required in Manufacturing (M) Districts shall be that determined by §9198. (Ord. 793, §2, adopted 1982)
§9117 ADDITIONAL REQUIREMENTS
A. All new construction, exterior modifications to existing buildings or on-site work shall require a Site Development Permit. (Ord. 793, §2, adopted 1982)