Chapter 17.40
LIGHT INDUSTRIAL DISTRICT (LI)
Sections:
17.40.030 Development standards.
17.40.040 Other applicable regulations.
17.40.010 Purpose and intent.
The purpose of the light industrial district is to provide areas for light industrial uses and manage the development of these uses to minimize or eliminate nuisance factors and hazards, such as excessive smoke, dirt, glare, odors, vibration, heat, noise, increased surface water runoff, and radiation, to surrounding areas. (Ord. 1160 NS § 1, 1997).
17.40.020 Uses.
Examples of uses in the LI district are provided in Table 17.12.070. (Ord. 1160 NS § 1, 1997).
17.40.030 Development standards.
All development in the LI district shall comply with the following standards:
A. Minimum lot area: no limitation.
B. Minimum lot width: no limitation.
C. Yard requirements:
1. Front yard: zero feet.
2. Rear yard: zero feet; except 20 feet where abutting an R district.
3. Side yard: five feet.
D. Maximum lot coverage: 100 percent.
E. Building height: no limitation.
F. Automobile, manufactured home, or recreational vehicle (RV), marine craft, or heavy equipment sales lots shall be drained and surfaced with crushed rock or asphalt paving as approved by the city public works department, except those portions of the lot maintained as landscape areas. (Ord. 1563 NS § 7, 2016; Ord. 1324 NS § 3, 2004; Ord. 1160 NS § 1, 1997).
17.40.040 Other applicable regulations.
In addition to the requirements contained in this chapter, the requirements contained in Article III, Supplementary Standards, Chapter 17.64 CMC, and Chapter 17.72 CMC, Off-Street Parking and Loading, shall also apply to development in the LI district. (Ord. 1563 NS § 8, 2016; Ord. 1160 NS § 1, 1997).