Chapter 17.44
INDUSTRIAL DISTRICT (I)
Sections:
17.44.030 Development standards.
17.44.040 Other applicable regulations.
17.44.010 Purpose and intent.
The purpose of the industrial district is to preserve land for industries which may create a greater degree of hazard or more annoyance than would be permitted in any other use district. Uses such as residential and some retail businesses are not permitted in this zone in order to encourage heavy industry to locate in areas where their operation will be neither injurious to nor hindered by these uses. (Ord. 1160 NS § 1, 1997).
17.44.020 Uses.
Examples of uses in the I district are provided in Table 17.12.070. (Ord. 1160 NS § 1, 1997).
17.44.030 Development standards.
All development in the I district shall comply with the following standards:
A. Minimum lot area: no limitation.
B. Minimum lot width: no limitation.
C. Yard requirements:
1. Front yard: zero feet; except 50 feet where abutting an R district.
2. Rear yard: zero feet; except 50 feet where abutting an R district.
3. Side yard: zero feet; except 50 feet where abutting an R district.
D. Maximum lot coverage: 100 percent.
E. Building height: no limitation. (Ord. 1324 NS § 4, 2004; Ord. 1160 NS § 1, 1997).
17.44.040 Other applicable regulations.
In addition to the requirements contained in this chapter, the requirements contained in Article III, Supplementary Standards, shall also apply to development in the I district. (Ord. 1160 NS § 1, 1997).